Instructions for Use

Setting Your Personal Combination

Setting the Ratchet takes only a few seconds. Simple follow the instructions below! We recommend reading all the steps once before starting.

• Step 1. Combination must be on current opening number prior to resetting. (The combination is factory set at >>0-0-0<<)

• Step 2. Locate the change screw (1) as shown below. Push inward with a small screwdriver & rotate the change screw 90 degrees clockwise. The change screw will now be recessed inside the lock body.

• Step 3. Set personal combination by turning dials to desired combination. Rotate the screw back counterclockwise until the screw is now flush with the surface. The combination is now set.

• Step 4. Test the combination by setting the combination to the new code. The ratchet bar release (2) should rotate from red to green & slide the lock off the ratchet bar.

• NOTE: To reset the combination in the future, the combination must be set to current opening code prior to turning the change screw.

To Open

• Either set the combination to the opening number or insert the master key and turn.
• Turn the ratchet bar release from red to green to release the bar.

Related Topics

Recovering a Lost Combination

#2

Screw is now in change mode when  recessed in vertical position.